Table of Contents .........................................................2
- User Manual Goodmans 12v Landscape Transformer 200 W 2
- User Manual Goodmans 12v Landscape Transformer 200 W Box
- User Manual Goodmans 12v Landscape Transformer 200 W Amp
GOODSMANN 200 Watt Power Pack with Sensor and Weather Shield for Low Voltage Landscape Lighting and Spotlight Outdoor Transformer 120V Input 12V Output 9920-0200-01 -Amazon.com.
Safety Information ........................................................2
Warranty .........................................................3
What is Covered ....................................................................
What is Not Covered ..............................................................
Pre-installation ............................................................4
Tools Required ...................................................................
Hardware Included ................................................................
Package Contents ................................................................
User Manual Goodmans 12v Landscape Transformer 200 W 2
Installation ...................................................................5
Operation ...................................................................8
Troubleshooting .........................................................10
Cable Selection Chart ..............................................10
Safety Information
IMPORTANT SAFETY INFORMATION TO REDUCE RISK OF FIRE OR INJURY.
User Manual Goodmans 12v Landscape Transformer 200 W Box
♦Do not install within 10 feet (3 m) of a pool, spa or fountain.
♦For use with low voltage outdoor landscape lighting system only.
♦There are no serviceable parts inside the power supply unit. DO NOT DISASSEMBLE.
♦Do not connect two or more transformers in parallel.
♦Plug the power supply unit directly into a GFCI wet location outlet.
♦The maximum output of this transformer is 200 watts. Do not overload the transformer. Be sure that the total cumulative wattage of all
12 volt fixtures connected to the transformer is equal to or less than 200 watts.
PLEASE NOTE: This landscape light system must
be installed in accordance with all local codes and
contact a qualified electrician.
WARNING:Changes or modifications to this unit not
compliance could void the user’s authority to operate
Note:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Please contact 1-855-HD-HAMPTON for further assistance.
Setting the TIME ON/OFF
Using the TEST function
This setting allows you to control the time the lights turn on and
a) Press MENU until the TIME ON/OFF LED indicator is lit and press
b) When the AM and PM LED begin to flash, press the UP or DOWN
c) When the Hour begins to flash, press the UP or DOWN arrow to
d) When the Minute begins to flash, press the UP or DOWN arrow to
e) The display shows 'OFF' indicating that you can now set the OFF
f) When AM and PM begins to flash, press the UP or DOWN arrow
User Manual Goodmans 12v Landscape Transformer 200 W Amp
g) When the Hour begins to flash, press the UP or DOWN arrow to
h) When the Minute begins to flash, press the UP or DOWN arrow to
This setting allows you to test your landscape lighting after
Press MENU until the TEST LED indicator is lit and press OK.
The time of photocell feeling the external light signal: the lights will
turn on at dusk and off at dawn within 0.5 seconds.
daylight hours with the photocell installed on the
photocell for the lights to turn on. The photocell
needs to sense darkness inorder to function, even
in TEST mode. If no photocell is installed on the
transformer, the lights will turn on regardless of
defaults enter into the presently-set function
TEST, the transformer defaults enter into the
7
8
In the event of a power outage the transformer functions may need
In TEST mode, the display and LED indicator lights on the transformer
turn off after approximately 10 seconds of idle time. In all other
modes, this auto shutdown occurs after approximately 120 seconds.
Press any button to turn on the transformer display.
9
To restore the transformer to its original factory settings, press and
hold the OK button for 3 seconds. The display shows 88:88 and
resets to 12:00 after 1 second to indicate that the transformer is now